ARCTIC TP-3: Premium Performance Thermal Pad, 120 x 20 x 1.5 mm (Stackable to 2.0 mm Without Performance Loss), 4 Pieces - High Performance, Particularly Soft, Ideal Gap Filler, Bridging Gaps

These are awesome. I forgot what word they describe it with but they're super soft, just above liquid. This makes them deform under pressure, which is awesome as it gives a tighter fit and makes it so I don't have to worry about the tiny differences in the heights of different chips. My SSDs were absolutely cooking before (up to 70 quite quickly), and now they slowly climb up to 60; the highest I saw after an hour was 61, which is impressive. Any further gains would probably require liquid cooling so I'm happy with this. Overall, super impressed with these. I can't think of a single negative thing to say. The documentation was surprisingly insightful, too. Read it.

Came as described, very easy to use and cut, high quality and my graphics card is running significantly cooler after repadding it

Really good quality and longevity. Thickness was accurate and was able to cut to size. Very easy to apply and peel. Saw temps go down on my devices by about 8-15degrees.

Used these to replace the absolutely gummy old thermal pads in an Xbox One X I repaired. You kinda have to be patient when it comes to applying them, as there's not much adhesive, but it does its job well.Posted a vid on YT under Silicon Seraph, if anyone's interested in the application in regard to Xbox One console repair. Would recommend!

The product seems to have decent performance. It comes in 4 precut peices, however it is very difficult to tell ar first glance. The bottom plastic plate is one solid piece but if you pull at the top where the blue plastic is you can start peeling the separate pieces. Make sure you keep the blue plastic untill you stick it on your ssd , etc. The pieces are pre-cut widthwise for a ssd drive (most of them) but you are going to have to adjust the lenght with scissors. Overall the engineering job of the packaging was i china flop. If you ar buying this for a laptop it is a better idea to figure out what is the space from the chip/ssd where you are going to install it to the lid of the laptop. As this is heat transfer material it works by connecting both surfaces together where the lid of your device will be used as a heatsink. Therefore a metal chassis laptoo would be effective when using this product where as a plastic one would less to no use to using this product. Stacking this product at least once, looks to be ok. The other way to play around is of you have a fan effective moving the air from where the pad is being installed. Other instances of using this product won't give any usefull results.

Nice and easy thermal pads to cut that I put in my MSI GS75 laptop.Seems to be working good, in addition I was also able to clean the fans and apply MX-6 as well :)Maybe the 1.5 thicknesss would have worked as well but it looked close enough. Didn’t want to take apart everything again.Still have a little extra left to in my specific case, thought I read that they do eventually degrade over time.Good value for the cost.

It's working good for my gen 5 nvme. Keeping it nice and cool in combination with the new heat sink. The thermal pads the heat sink came with were too thin, these 1.5 mm bad boys were much better.

Good replacement for my 2019 Razer Blade. Did the job well.